Measurement of Limit Gauges
Posted by mechlook info on December 11th, 2011 09:00 AM | No Comment
Before making any dimensional measurement of limit gauges, preliminary inspection is made about in general and the non-gauging dimensions of the gauges checked. In addition, the flatness, hardness and straightness of the gauging surfaces are also checked. The checking of ...
Multi-Dimension Automatic Gauging and Sorting Machines- testing nad calibraton of guages
Posted by mechlook info on December 8th, 2011 05:18 PM | No Comment
While for manual inspection, it can said that 100% inspection in likely to lead to operator fatigue and acceptance of faulty components. Same is not true for automatic inspection machines. These can carry out 100% inspection without fatigue and thus ...
Laser Telemetric System- Testing and calibration of guages
Posted by mechlook info on November 12th, 2011 09:07 AM | No Comment
Laser telemetric system is a non-contact gauge that measures with a collimated laser beam (Refer Fig.below).
It measures at the rate of 150 scans per second. It basically consists of three components, a transmitter, a receiver and processor electronics. The transmitter ...